Case 980 Excavator Service (9-73476) Case 980 Repair Manual Digital PDF

Description

CASE 980 Excavator SERVICE REPAIR MANUAL (9-73476) CASE 980

CASE 980 EXCAVATOR SERVICE REPAIR MANUAL (9-73476) CASE 980 – PDF DOWNLOAD:

Image Preview:

Description:

CASE 980 Excavator SERVICE REPAIR MANUAL (9-73476) CASE 980

RUN-IN-INSTRUCTIONS

Engine Lubrication
When the engine rebuild is complete, fill the engine crankcase with Case HDM oil and install new engine oil filters. NOTE: If Case HDM oil is not used, use only a Series 3 DS or CD Service Classification oil that has the proper viscosity rating for prevailing air temperature. Refer to vehicle Operators Manual.
After the first 20 hours of operation, change the engine oil while the engine is hot and replace the the engine oil filter/s. DO NOT DRAIN OIL UNTIL THE ENGINE HAS BEEN OPERATED 20 HOURS. Change the engine oil and filter/s at the recommended intervals thereafter as outlined in the Operator’s Manual.
Run-In Procedure (Agricultural Tractors)
For the first 8 hours of field operation stay one gear lower than normal. For the next 12 hours DO NOT “lug” the engine. Prevent “lugging” by shifting to a lower gear. The engine must not be “lugged” below its Rated Engine RPM during the early hours of life.
Run-In Procedure (Construction Equipment)
For the first 8 hours, operate the engine at full throttle maintaining a normal load. DO NOT baby the engine, but avoid prolonged converter or hydraulic stall. Engine must not be “lugged” below its Rated Engine RPM (Do not exceed 10 seconds of stall).
Run-In Procedure (Power Units)
For the first 1/2 hour, operate engine at 2/3 rated RPM with a light load or no load. For the next (1) hour, run engine at 80 to 90% load at rated RPM (but not over 2000 RPM). Then full load and rated RPM as required in application.

Table of Contents:

CASE 980 Excavator SERVICE REPAIR MANUAL (9-73476) CASE 980

Table of Contens ....................  2
10 Series - General .................  4
20 Series - Engine
.................. 40
30 Series - Fuel System
.............224
40 Series - Hydraulics
 .............272
50 Series - Track and Suspension
....394
60 Series - Power Train
.............408
70 Series - Brakes
..................464
80 Series - Electrical
..............476

Please Note:

⦁ This is the SAME manual used by the dealers to troubleshoot any faults in your vehicle. This can be yours in 2 minutes after the payment is made.
⦁ Contact us at [email protected] should you have any queries before your purchase or that you need any other service / repair / parts operators manual.