Claas Combines VARIO CERIO 528 MAXFLEX 530/534 Anti-wrap guard Fitting instructions Manual_DE_EN_FR

Description

Claas Combines VARIO CERIO 528 MAXFLEX 530/534 Anti-wrap guard Fitting instructions Manual_DE_EN_FR – PDF DOWNLOAD

DESCRIPTION:

Claas Combines VARIO CERIO 528 MAXFLEX 530/534 Anti-wrap guard Fitting instructions Manual_DE_EN_FR

VARIO/CERIO 528
MAXFLEX 530/534
Anbauanleitung
Wickelschutz
Fitting Instructions
Anti-wrap guard
Notice de montage
Dispositif anti-enroulement
Instrucciones de montaje
Dispositivo contra enrollamiento
Istruzioni per il montaggio
Antiavvolgente
Руководство по установке
Защита от наматывания
Instrukcja dołączania
Osłona przeciwnawinięciowa
Instucţiuni de ataşare
Apărători de înfăşurare
安装说明书
防缠绕装置
Montagehandleiding
Wikkelbescherming
Monteringsvejledning
Svøbejern
Monteringsanvisning
Lindningsskydd
Monteringsveiledning
Viklingsbeskyttelse
Asennusohje
Kietoutumissuoja
Paigaldusjuhend
Mähkumiskaitse
Uzstādīšanas instrukcija
Tītavu aizsargs
Montavimo instrukcija
Apsauga nuo apsivyniojimo
Szerelési utasítás
Feltekerés elleni védőburkolat
Montážní návod
Kryt proti navíjení
Upute za montažu
Zaštita od namatanja

Safety

Work may only be carried out by a qualified specialist
workshop employing trained specialist workers.
The general safety, accident prevention and
environmental protection regulation must be
observed.
Before starting work on the machine, read and
observe the safety precautions in the Operator’s
Manual and the safety decals on the machine.
All work must be carried out with the drive disengaged
and the engine stopped! – Remove the ignition key!
Carry out work beneath a raised machine/front
attachment or raised components only if a safe
support is provided.
Before carrying out work on the hydraulic system,
lower the machine/front attachment and hydraulically
actuated components to the ground. Depressurise the
system.
Relieve the tension of pre-loaded energy
accumulators (springs, accumulators, hydraulic
cylinders) and of components which are pre-loaded
by energy accumulators properly prior to starting
installation work!
When parts with safety decals on them are replaced,
ensure that the relevant safety decals are applied
again to the new parts.
Refit any dismounted safety guards and other parts
before putting back into operation and move them to
their protective position.
Check the tight seat of all bolts after assembly. Carry
out a function test.
The dimensions given follow the metric system. The
corresponding U.S. dimensions are added in
brackets.
IMAGES PREVIEW OF THE MANUAL:

PLEASE NOTE:

• This is the exact same manual used by your dealerships to service your vehicle.
• The same can be yours in the next 2-3 minutes as you will be directed to the download page immediately after paying for the manual.
• For any questions/doubts regarding your purchase, please do not hesitate to contact [email protected]

S.M.