Claas Forage Harvesters ORBIS 600 SD Angle finger Fitting instructions Manual_DE_EN_FR – PDF DOWNLOAD

Description

Claas Forage Harvesters ORBIS 600 SD Angle finger Fitting instructions Manual_DE_EN_FR – PDF DOWNLOAD

DESCRIPTION:
Claas Forage Harvesters ORBIS 600 SD Angle finger Fitting instructions Manual_DE_EN_FR – PDF DOWNLOAD

ORBIS 600 SD
Anbauanleitung
Eckfinger
Fitting instructions
Angle finger
Instructions de montage
Doigt angulaire
Istruzioni di montaggio
Dita angolari
Instrucciones de montaje
Dedo esquinero
Руководство по монтажу
Instrukcja dołączania
安装说明

General instructions
Safety precautions
Work may be carried out only by specialist
workshops authorised by CLAAS and having
qualified personnel.
The general safety, accident prevention and environmental
protection regulation must be observed.
Read and observe the Safety chapter in the Operator’s
manual.
Carry out work under the raised machine/front attachment
or raised components only when a safe support
is provided.
Before carrying out work on the hydraulic system,
lower machine/front attachment and hydraulically
actuated components to the ground. Depressurise
the system.
All work must be carried out with the drive disengaged
and the engine stopped! – Remove the
ignition key!
Relieve the tension of pre-loaded energy accumulators
(springs, accumulators, hydraulic cylinders) and
of components which are pre-loaded by energy accumulators
properly prior to starting installation work!
Check the tight seat of all bolts after assembly.
Carry out a function test.
IMAGES PREVIEW OF THE MANUAL:

PLEASE NOTE:

• This is the exact same manual used by your dealerships to service your vehicle.
• The same can be yours in the next 2-3 minutes as you will be directed to the download page immediately after paying for the manual.
• For any questions/doubts regarding your purchase, please do not hesitate to contact [email protected]

S.M.