Claas Forage Harvesters RU 450 Xtra Feed cone Fitting instructions Manual_DE_FR_EN – PDF DOWNLOAD

Description

Claas Forage Harvesters RU 450 Xtra Feed cone Fitting instructions Manual_DE_FR_EN – PDF DOWNLOAD

DESCRIPTION:

Claas Forage Harvesters RU 450 Xtra Feed cone Fitting instructions Manual_DE_FR_EN – PDF DOWNLOAD
General instructions
Safety precautions
Work may be carried out only by specialist
workshops authorised by CLAAS and having
qualified personnel.
The general safety, accident prevention and environmental
protection regulation must be observed.
Read and observe the Safety chapter in the Operator’s
manual.
Carry out work under the raised machine/front attachment
or raised components only when a safe support
is provided.
Before carrying out work on the hydraulic system,
lower machine/front attachment and hydraulically
actuated components to the ground. Depressurise
the system.
All work must be carried out with the drive disengaged
and the engine stopped! – Remove the
ignition key!
Relieve the tension of pre-loaded energy accumulators
(springs, accumulators, hydraulic cylinders) and
of components which are pre-loaded by energy accumulators
properly prior to starting installation work!
Check the tight seat of all bolts after assembly.
Carry out a function test.

PLEASE NOTE:

• This is the exact same manual used by your dealerships to service your vehicle.
• The same can be yours in the next 2-3 minutes as you will be directed to the download page immediately after paying for the manual.
• For any questions/doubts regarding your purchase, please do not hesitate to contact [email protected]

S.M