CLAAS JAGUAR 900 – 830 Remote Control for Knife Sharpening and Electric Shearbar Adjustment Fitting Instructions Manual_DE_EN_FR

Description

CLAAS JAGUAR 900 – 830 Remote Control for Knife Sharpening and Electric Shearbar Adjustment Fitting Instructions Manual_DE_EN_FR

DESCRIPTION:

CLAAS JAGUAR 900 – 830 Remote Control for Knife Sharpening and Electric Shearbar Adjustment Fitting Instructions Manual_DE_EN_FR

INTRODUCTION

These instructions describe the safe and timesaving work sequence for retrofitting the remote control sharpening and electric shear bar adjustment. The forage harvesters JAGUAR 900-830 from the following machine number ranges 49200011 can be retrofitted with the supplementary kit part no. 067 108.0. The forage harvesters JAGUAR 900-830 from the following machine number ranges 49202210 can be retrofitted with the supplementary kit part no. 91004360. The standard mounting time is approx. 4 man hours. See page 4.1 for the shipping package. Observe the »Safety Rules« in the applicable operator’s manual.
TABLE OF CONTENTS:

CLAAS JAGUAR 900 – 830 Remote Control for Knife Sharpening and Electric Shearbar Adjustment Fitting Instructions Manual_DE_EN_FR

1 Introduction
Introduction 11
2 Contents
Contents 21
3 General
information
Important 31
Identification of warnings and danger signs 32
Correct use 32
4 Shipping Package
Shipping Package 41
Supplementary kit 91004360 from machine no 49202210
Supplementary kit 067 1080 up to machine no 49202209 41
5 Installation
Installing remote control for sharpening device and electric shear
bar adjustment 51
Removing the feeder housing 51
Installing the drives on both sides 53
Pre-assembling the drive left and the drive right 54
Installing the knock sensor (1) 54
Installing the magnet (6) and
the plate with the flat switch (8) 55
Installing the wiring loom for the shear
bar adjustment (1) 55
Installing the wiring loom for the remote
control (1) and the module (10) 56
Installing the nominal value sender for
the gap adjustment 511
Connecting the nominal value sender for
the gap adjustment to the electric system 511
Installing the nominal value sender
for the grinding cycles 512
Connecting the nominal value sender
for the grinding cycles to the elctric system 512
Installing the toggle switch (5) 513
Connecting the toggle switch (5) to the
electric system 513
Installing the display completely 513
Connecting the indicator light (9) to the
electric system 514
Installing the control relay (10) 514
Assembling the switch console 515
Installing the safety features 515
Installing the feeder housing 515
Preparing and performing a test run 516
IMAGES PREVIEW OF THE MANUAL:

CLAAS JAGUAR 900 – 830 REMOTE CONTROL FOR KNIFE SHARPENING AND ELECTRIC SHEARBAR ADJUSTMENT FITTING INSTRUCTIONS MANUAL_DE_EN_FR:

PLEASE NOTE:

• This is the same manual used by the DEALERSHIPS to SERVICE your vehicle.
• The manual can be all yours – Once payment is complete, you will be taken to the download page from where you can download the manual. All in 2-5 minutes time!!
• Need any other service / repair / parts manual, please feel free to contact us at heydownloadss @gmail.com . We may surprise you with a nice offer

S.M