CLAAS MEGA 360 350 MEDION 340-310 MEDION 330 H Fitting Instructions Manual – PDF DOWNLOAD

Description

CLAAS MEGA 360 350 MEDION 340-310 MEDION 330 H Fitting Instructions Manual – PDF DOWNLOAD

DESCRIPTION:

CLAAS MEGA 360 350 MEDION 340-310 MEDION 330 H Fitting Instructions Manual – PDF DOWNLOAD

General information
IMPORTANT :

The instructions contained in this manual should be carefully read and observed by all persons who are concerned with the operation, maintenance and inspection of this machine/ front attachment in order to prevent accidents. Especially the »Safety Rules« in the operator’s manual should be read with the utmost care and adhered to.

• In addition, please also observe the accident prevention regulations that apply for your own country. Before commencing with the job, ensure that all the tools and service aids are available. Compare existing machine type/front attachment type with the list in the chapter »Shipping Package« and the parts kit supplied.
• The specification of the components, e.g. bolts, is shown on the shipping package. The shipping package shows the position number (pos. no.) of the components.
• Parts such as nuts and contact washers do not have a position number but belong to the bolt listed above which does have a position number. Additional part specifications are the part no., description, measurements, DIN and the quantity.

TABLE OF CONTENTS:

CLAAS MEGA 360 350 MEDION 340-310 MEDION 330 H Fitting Instructions Manual – PDF DOWNLOAD

1 Introduction
Introduction 1 1
2 Contents
Contents 2 1
3 General
information
Important 3 1
Identification of warnings and danger signs 3 2
Correct use 3 2
4 Shipping Package
Shipping Package 4 1
Supplementary kit 000 759 704 0 4 1
5 Installation
Fitting the 3-D cleaning system for the sieve pan 5 1
Preparing the installation 5 1
Removing the rocker arm 5 1
Fitting the holder with accessories 5 2
Fitting the pendulum control unit with accessories 5 5
Creating vacuum in the hydraulic lines 5 7
Removing the cab rear panel 5 8
Setting the sieve pan to the middle position 5 11
Setting the 3-D cleaning system 5 13
Setting the pivot arm 5 15
Bleeding the pendulum control (30) 5 16
Removing the guiding plates 5 16
Preparing and performing the test run 5 16

CLAAS MEGA 360 350 MEDION 340-310 MEDION 330 H FITTING INSTRUCTIONS MANUAL – PDF DOWNLOAD:

IMAGES PREVIEW OF THE MANUAL:

PLEASE NOTE:

• This is the SAME MANUAL used by the dealerships to diagnose your vehicle
• No waiting for couriers / posts as this is a PDF manual and you can download it within 2 minutes time once you make the payment.
• Your payment is all safe and the delivery of the manual is INSTANT – You will be taken to the DOWNLOAD PAGE.
• So have no hesitations whatsoever and write to us about any queries you may have : heydownloadss @gmail.com

S.V