Clark Forklift PMA-510 ECAEPA Planned Maintenance and Adjustment Manual

Description

Clark Forklift PMA-510 ECAEPA Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

Image Preview:

Description:

Clark Forklift PMA-510 ECAEPA Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

• Powered industrial trucks may become hazardous if adequate maintenance is not done. Therefore, maintenance facilities, personnel and procedures must be provided. Maintenance and inspection of all powered industrial trucks should be done in agreement with the recommendation in this manual and the following practices. 1. A scheduled preventive maintenance, lubrication, and inspection system must be followed. 2. Only qualified and authorized personnel should be permitted to maintain, repair, adjust, and inspect industrial trucks.
• 3. Before Leaving The Truck: A. Stop Truck. B. Fully lower the load engaging means. C. Put directional controls in neutral. D. Apply the parking brake. E. Stop the engine or turn off power. F. Lock the control or ignition circuit. G. Put blocks at the wheels if truck is on a ramp, or being worked on. 4. Before Working On Truck: A. Raise wheels free of floor or disconnect power source.
• B. Use blocks or other positive truck positioning devices. C. Put blocks under the load engaging means, inner-mast(s), or chassis before working under them. Before working on engine fuel system of gasoline powered trucks with gravity feed fuel systems, make sure fuel shutoff valve is closed. Before working on engine fuel system of LP gas powered trucks, close LP gas cylinder valve and run engine until there is no more fuel in the system and engine stops running.
• Operation to check performance of the truck or attachments must be done in a clear, authorized, safe area. 5. Before Starting To Operate The Truck: A. B. C. D. E. F. Be in operating position.
• Push clutch (or brake pedal on automatic transmission and electric trucks). Put the directional controls in neutral. Start engine or turn on power. Before operating truck, check functioning of lift and tilt systems, directional and speed controls, steering, warning devices, brakes, and any attachment. (If used) Release parking brake.

Table Of Contents:

Clark Forklift PMA-510 ECAEPA Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

LUBRICATION CHARTS
SEAT CONTROL ROD ADJUSTMENT
DIRECTIONAL CONTROL LEVER ADJUSTMENT
HORN AND STEERING HANDWHEEL ADJUSTMENT
ELECTRIC TRUCK BATTERY MAINTENANCE
ELECTRIC TRUCK BATTERY STANDARD U.L. 583
ELECTRIC MOTOR MAINTENANCE
DRIVE MOTOR BRUSH REPLACEMENT – GE
DRIVE MOTOR BRUSH REPLACEMENT – PRESTOLITE
EV-1 #l CARD INITIAL ADJUSTMENT SETTINGS
PUMP AND TRACTION CONTROL LED CHECK
DRIVE UNIT MAINTENANCE
PNEUMATIC TIRE AND WHEEL MAINTENANCE
PARKING BRAKE RELEASE
BRAKE BLEEDING PROCEDURE
STEER WHEEL BEARING MAINTENANCE
POWER STEERING RELIEF PRESSURE CHECK
HYDRAULIC SUMP FLUID AND FILTER CHANGE
HYDRAULIC SYSTEM RELIEF PRESSURE CHECK AND ADJUSTMENT
HYDRAULIC SYSTEM SCHEMATIC DIAGRAM
TILT CYLINDER ADJUSTMENT
TILT CYLINDER DRIFT TEST
UPRIGHT LIFT CHAIN CHECK AND ADJUSTMENT
UPRIGHT DOWNDRIFT TEST
FORK WEAR INSPECTION
LIFT CHAIN MAINTENANCE

Please Note:

• This is not a physical manual but a digital manual – meaning no physical copy will be couriered to you. The manual can be yours in the next 2 mins as once you make the payment, you will be directed to the download page IMMEDIATELY.
• This is the same manual used by the dealers inorder to diagnose your vehicle of its faults.
• Require some other service manual or have any queries: please WRITE to us at [email protected]

Sk