Clark Forklift PMA 540 SERIAL 540-5001 Planned Maintenance and Adjustment Manual

Description

Clark Forklift PMA 540 SERIAL 540-5001 Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

Image Preview:

Description:

Clark Forklift PMA 540 SERIAL 540-5001 Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

• Powered industrial trucks may become hazardous if adequate maintenance is not done. Therefore, suitable maintenance facilities, personnel, and procedures must be provided. Maintenance and inspection of all powered industrial trucks should be done in agreement with the recommendations in this manual and the following practices: I. A scheduled preventive maintenance, lubrication, and inspection program must be followed.
• 2. Only qualified and authorized personnel should be permitted to maintain, repair, adjust, and inspect industrial trucks. 3. Operation to check performance of the truck or attachments must be done in an authorized, safe, clear area. 4. Before Startina To Drive The Truck: 1) Be in operating position. 2) Push clutch (or brake pedal on automatic transmission and electric trucks).
• 3) Put directional control in neutral. 4) Start engine or turn on power. 5) Before operating truck, check functioning of lift and tilt systems, directional and speed controls, steering, warning devices, brakes, and any attachments. 6) Release parking brake. 5. Before Leavina The Truck: 1) Stop truck. 2) Fully lower the load engaging means. 3) Put directional control in neutral. 4) Apply the parking brake. 5) Stop the engine or turn off power. 6) Lock the control or ignition circuit. 7) Put blocks at the wheels if truck is on a ramp, or being worked on.
• 6. Before Workina On Truck: 1) Raise wheels free of floor or disconnect power source. 2) Use blocks or other positive truck positioning devices. 3) Put blocks under the load engaging means, innermast( or chassis before working under them. 7. Before working on engine fuel system of gasoline powered trucks with gravity-feed fuel systems, be sure fuel shutoff valve is closed.
• 8. Before working on engine fuel system of LP-gas powered trucks, close LP-gas cylinder valve and run engine until there is no more fuel in the system and engine stops running.

Table Of Contents:

Clark Forklift PMA 540 SERIAL 540-5001 Planned Maintenance and Adjustment Manual – PDF DOWNLOAD

Lubrication Charts
Electric
Electric
Charging
Electric
Truck Battery
Battery Powered Industrial Trucks – U.L. 583
Procedures – Electric Truck Battery Pack
Motor Maintenance
Drive Unit
Hydraulic Tank – Drain, Clean, Fill
Lift Cylinder Drift Test
Decals, Nameplates, and Serial Number Data
Suggested Equipment for Electric Truck P.M.
PM Inspection and Driver’s Daily Inspection Forms
PM Safety and PM Cautions – Fire Extinguisher Recommendations
Safety Instructions for Maintaining Industrial Trucks
Lubrication Chart Key – Lubrication Specifications
Truck Specifications
Electrical Schematic Diagram (See rear of manual)
Hydraulic Schematic Diagram (See rear of manual)

Please Note:

• This is the SAME MANUAL used by the dealerships to diagnose your vehicle
• No waiting for couriers / posts as this is a PDF manual and you can download it within 2 minutes time once you make the payment.
• Your payment is all safe and the delivery of the manual is INSTANT – You will be taken to the DOWNLOAD PAGE.
• So have no hesitations whatsoever and write to us about any queries you may have : heydownloadss @gmail.com

Sk