Dodge Sprinter Body Repair Manual – PDF DOWNLOAD

Description

Dodge Sprinter Body Repair Manual – PDF DOWNLOAD

FILE DETAILS:

Dodge Sprinter Body Repair Manual – PDF DOWNLOAD

Language : English
Pages : 507
Downloadable : Yes
File Type : PDF

IMAGES PREVIEW OF THE MANUAL:

DESCRIPTION:

Dodge Sprinter Body Repair Manual – PDF DOWNLOAD

SAFETY:

• Risk of injury. Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units.
• Store airbag unit with the deployment face up, do not subject to temperatures above 100°C. When working on these units, disconnect power supply.
• Risk of injury Injuries may be caused by flying objects if an airbag or emergency tensioning retractor (ETR) unit is triggered accidentally or if an airbag unit is stored with its deployment face down.

Safety instructions/precautions:

• Always store removed airbag units with the deployment face up.
• The procurement, transport, storage, testing and installation of these units must be performed or supervised by specially trained personnel. – Install airbag and ETR units immediately following retrieval from storage.
• Protect airbag and ETR units from sparks, open flames and temperatures above 100°C.
• Do not transport airbag or ETR units in the passenger compartment; pack in original replacement part packaging only and secure tightly in the load compartment of the vehicle.
• Do not allow grease, oil or cleaning agents to come into contact with airbag or ETR units. – Perform system tests using approved testing equipment only (e.g. Star Diagnosis) and only when the units are properly installed and the vehicle is unoccupied.
• Initial hook-up of the battery of an external power supply may only be done when the ignition is switched on and when the vehicle is unoccupied.
• If an airbag or ETR unit falls from a height of more than 0.5m, it must be replaced. –
• For proper and safe scrapping, airbag and ETR units must be sent in their original packaging for disposal via the established MeRSy disposal system (Renz company).
• Proper and safe scrapping shall be done in compliance with the applicable regulations of the country concerned.
• Remove key from starter
• Disconnect and isolate the battery ground cable
• Disconnect any external power sources (e.g. charging equipment)
• Pull plug from control module prior to performing work inside the passenger compartment and prior to any welding work

G.B 07/04/25