Electrolux Side-by-Side Refrigerator Service Manual (Diagnostics & Wiring) PDF

Description

Electrolux Side-by-Side Refrigerator Service Manual (Diagnostics & Wiring) PDF DOWNLOAD

Description

🧊 Side-by-Side Refrigerator — Service Manual (PDF)

This Side-by-Side Refrigerator Service Manual is a complete workshop reference for troubleshooting and repairing common and advanced issues—no-cool, warm temps, defrost failures, fan problems, control board faults, dispenser/ice maker issues, and sealed-system service. It includes service tests/diagnostic mode, wiring diagrams, performance data, and step-by-step replacement procedures.

Table of Contents (Neatly Categorized)

✅ Safe Servicing Practices

• Safe servicing rules, grounding guidance, technician safety warnings

SECTION A — Installation

• Uncrating

• Model and Serial Number

• Air Circulation

• Electrical Information

• Leveling

• Door Removal

  • To Remove Refrigerator Door

  • To Remove Freezer Door

• Door Alignment

SECTION B — Refrigerator Cabinet

• Basic Construction

• Compressor Mounting

• Insulation and Inner Liner

• Cabinet Doors and Gaskets

• Adjustable Door Bins

• Front and Rear Rollers

  • To Remove Front Roller Assembly

  • To Remove Rear Roller

• Cabinet Touch-Up Procedure

  • Lacquer Refinishing

SECTION C — Electrical Components

• Electrical Grounding

• Compressor

  • Electrical Components and Circuits

  • Solid State Relay

    • To Check/Replace Relay

  • Overload Protector

    • To Check/Replace Overload Protector

  • Run Capacitor

    • To Check/Replace Run Capacitor

  • Compressor Start Circuit / Run Circuit

  • Compressor Operating Characteristics

  • Compressor Electrical Check

• Perimeter and Mullion Hot Tube

• Evaporator Fan & Motor Assembly

  • To Remove Evaporator Fan Motor

• Defrost Thermostat

  • To Test Defrost Thermostat

  • To Remove Defrost Thermostat

• Defrost Heater

  • How To Remove Defrost Heater

SECTION C — Electronic Controls

• Electronic Control System

  • Damper Assembly

  • Freezer Temperature Control

  • Fresh Food Temperature Control

  • Defrost Heater / Defrost Termination Thermostat (DTT)

  • Standard Compressor / Evaporator Fan / Condenser Fan

  • Fresh Food Door Sensor / Air Filter / Sensors / Lights / Alarm

  • Main Control Board / User Interface / Numeric Display

  • Fahrenheit & Centigrade / Showroom Setting

• Alarms and Signals (door ajar, high temp, power failure, alarm OFF)

• Showroom Setting (activation/deactivation, active functions)

• Change Between Fahrenheit & Centigrade

• Advance Into Defrost Cycle Manually

• Operation (Updated Revision L)

  • User Interface Version A

  • User Interface Version B

• Diagrams

  • Diagram A: Main Board / Diagram B: User Interface Board

  • Wiring Diagrams

  • Performance Data Sheet

• Service Diagnostic Mode

  • View / Test / Deactivation

  • Service Test Menu (Firmware, fans, temp history, damper, defrost, compressor)

  • Manual Defrost / Show Room Mode / °F↔°C display routine

• Control Removal & Installation

  • Control Board service / Power Board service / Damper replacement

  • Food Compartment Light Switch

• System Exploded View

SECTION D — Air Circulation

• Principles of automatic defrost operation

• Air circulation patterns

SECTION E — Refrigeration System (Sealed System Service)

• Definitions: Recovery / Recycling / Reclaim

• Safety Warnings (compressor testing, charging sealed systems, soldering)

• Basic Components

• Refrigerant Cycle

• Testing for Refrigerant Leaks

• Checking for Internal (Hot Tube) Leaks

• Compressor Replacement (including flushing methods + install new compressor)

• Evaporator Replacement

• Heat Exchanger Replacement

• Perimeter Hot Tube Repair Kit (bypass + heater wire steps)

• Condenser Replacement

• Filter-Drier Installation

• Evacuating and Recharging (equipment, evacuation, charging, final leak test)

• R-134a Service Information

  • Refrigerant properties, leak detection, pressure-temp chart

  • Health and safety information

SECTION F — Ice Maker

• Rear mounted ice maker for counter depth models

• Components (mold heater, ejector, valves, thermostat, timing switches, motor, wiring)

• Installing water supply line / test cycling

• Parts replacement procedures (cover, trough, stripper, motor, switches, thermostat, TCO, heater)

• Fault diagnosis (won’t start / won’t complete cycle / won’t stop / small cubes)

• Ice maker testing procedures

• Operating cycle illustrations (manual/electrical/mechanical)

• Ice maker wiring diagrams

SECTION G — Ice & Water Dispenser

• Ice dispenser container & rail assembly

• Auger motor & solenoid assembly (remove/test)

• Lamp socket & bulb replacement

• Ice auger & crusher assembly (remove/replace blades)

• Dispenser assembly (multiple feature levels)

• Access steps + Fast Freeze / Fast Ice

• How to test the electronic dispenser

SECTION H — Water Systems

• Water valve

• PureSource water filters

• Water tanks / front & rear filter systems

• Test the water fill system

• Resistance/voltage checks (including “no water at door” scenarios)

• Diode kit / valve coil checks / chilled water valve / ice maker valve

📌 File Details

Stop guessing—use the diagnostic mode, wiring diagrams, and sealed-system procedures to fix it right the first time. Download instantly and start troubleshooting like a pro today.