Massey Ferguson EU Tractor DANA 770-504 8650 8660 8670 8680 8690 Tier 3 Service Manual – PDF DOWNLOAD

Description

Massey Ferguson EU Tractor DANA 770-504 8650 8660 8670 8680 8690 Tier 3 Service Manual – PDF DOWNLOAD

DESCRIPTION:

Massey Ferguson EU Tractor DANA 770-504 8650 8660 8670 8680 8690 Tier 3 Service Manual – PDF DOWNLOAD

INTRODUCTION:

• The efficiency and continued operation of mechanical units de- pend on constant, correct maintenance and also on efficient repair work, should there be a break-down or malfunction. The instructions contained in this manual have been based on a com- plete overhaul of the unit. However, it is up to the mechanic to decide whether or not it is necessary to assemble only individual components, when partial repair work is needed.
• The manual provides a quick and sure guide which, with the use of photo- graphs and diagrams illustrating the various phases of the ope- rations, allows accurate work to be performed.All the information needed for correct disassembly, checks and assembly of each individual component is set out below. In order to remove the differential unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle.

IMPORTANT:

In order to facilitate work and protect both working surfaces and operators, it is advisable to use proper equipment such as: trestles or supporting benches, plastic or copper hammers, appropriate levers, pullers and specific spanners or wren- ches. Before going on to disassemble the parts and drain the oil, it is best to thoroughly clean the unit, removing any encrusted or ac- cumulated grease.

INTRODUCTORY REMARKS:

• All the disassembled mechanical units should be thoroughly cleaned with appropriate products and restored or replaced if damage, wear, cracking or seizing have occurred. In particular, thoroughly check the condition of all moving parts (bearings, gears, crown wheel and pinion, shafts) and sealing parts (O-rings, oil shields) which are subject to major stress and wear.
• In any case, it is advisable to replace the seals every time a component is overhauled or repaired. During as- sembly, the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one component requires the replacement of the other one. During as- sembly, the prescribed pre-Ioading, backlash and torque of parts must be maintained.

IMAGES PREVIEW OF THE MANUAL:

TABLE OF CONTENTS:

Massey Ferguson EU Tractor DANA 770-504 8650 8660 8670 8680 8690 Tier 3 Service Manual – PDF DOWNLOAD

INTRODUCTION
MAINTENANCE AND LUBRICANT
Data plate
Definition of viewpoints
Maintenance points
Maintenance intervals
Adjustment and checks
Screw-locking, sealing and lubricating materials
NOTES ON SAFETY PRECAUTIONS
Conversion tables
Tightening torques
PLANETARY REDUCTION
Assembly diagram
Disassembly
Assembly
STEERING SENSOR
Assembly diagram
Removal
Assembly
COMPLETE STEERING CASE
Assembly diagram
Disassembly
Install and adjust
STEERING CYLINDER – CONVERGENCY ADJUSTMENT
Assembly diagram
Disassembly
Install and adjust
HYDRAULIC DIFFERENTIAL LOCK
Assembly diagram
Disassembly
Install and adjust
BEVEL PINION
Assembly diagram
Disassembly
Install and adjust
SPECIAL TOOLS

MASSEY FERGUSON EU TRACTOR DANA 770-504 8650 8660 8670 8680 8690 TIER 3 SERVICE MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the SAME exact manual used by your dealers to fix your vehicle.
• The same can be yours in the next 2-3 mins as you will be directed to the download page immediately after paying for the manual.
• Any queries / doubts regarding your purchase, please feel free to contact [email protected]

S.V