Scania DC09 DC13 DC16 OC16 DI09 DI13 DI16 Electrical System Installation Manual – PDF DOWNLOAD

Description

Scania DC09 DC13 DC16 OC16 DI09 DI13 DI16 Electrical System Installation Manual – PDF DOWNLOAD

DESCRIPTION:

Scania DC09 DC13 DC16 OC16 DI09 DI13 DI16 Electrical System Installation Manual – PDF DOWNLOAD

Introduction:
Changes from the previous issue:

The changes made in this document compared with the previous issue are marked with a line in the left-hand margin. The changes are also described below.
• Information about harness-to-harness connectors C4125 and C4126: Throttle control for Stage V engines has been added to section Engine interface.
• The requirements for the electrical cables for OC16 ignition coils have been clarified in section C4094: Harness-to-harness connectors for ignition coils and throttle actuator at gas mixer.

Different requirements
For PDE engines, except marine engines with PDE and SCR systems, engine control unit S6 is used. For XPI engines and marine engines with PDE and SCR systems, engine control unit S8 is used. 16 litre gas engines use engine control unit OCE1. There are two different requirements for the electrical installation of S6 and S8: with or without Scania’s base system. This installation manual does not describe Scania’s electrical systems. Information about these can be found in

• 03:04 Instrumentation 2.1.
• 03:03 Instrumentation 2.0.
• 03:02 Coordinator and base system.

TABLE OF CONTENTS:

Scania DC09 DC13 DC16 OC16 DI09 DI13 DI16 Electrical System Installation Manual – PDF DOWNLOAD

Introduction 3
Changes from the previous issue 3
Different requirements 3
Grounding 3
Abbreviations 3
Safety during electric welding 4
Batteries and alternators 4
Batteries 4
Connection of batteries 5
Battery cables 6
Battery master switch 7
Alternator charging for marine engines 8
Marine engines with split ground system 8
Ground connection on gas engines 9
Electrical cables 10
Routing cables 10
Calculating cable cross-section 11
Splicing and repair 13
Connection to engine 14
Connection to engine without Scania base system 14
Current consumption of the electrical system 15
Engine interface 16
Pin numbering for harness-to-harness connectors 20
Starting and shutdown procedure for gas engines 31
Connection of starter motor or alternator 33
Connection of coolant level monitor 35
Connection of oil level sensor 39
Engine control unit41
Operating voltage 41
Protective ratings 41
Connection of limp home mode 42
Engine running signal 43
Connecting auxiliary equipment 44
Connection of the water separating prefilter on marine engines 44
Connecting fuel heaters for industrial engines with XPI 44
Installation of the supply connector for engine heater 45
Work description for harness-to-harness connectors 49
Harness-to-harness connector for engine interface 49
Harness-to-harness connector for engine control unit 52

SCANIA DC09 DC13 DC16 OC16 DI09 DI13 DI16 ELECTRICAL SYSTEM INSTALLATION MANUAL – PDF DOWNLOAD:

IMAGES PREVIEW OF THE MANUAL:

PLEASE NOTE:

• This is the same manual used by the DEALERSHIPS to SERVICE your vehicle.
• The manual can be all yours – Once payment is complete, you will be taken to the download page from where you can download the manual. All in 2-5 minutes time!!
• Need any other service / repair / parts manual, please feel free to contact us at heydownloadss @gmail.com . We may surprise you with a nice offer