Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up PDF
$8.95
Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up – PDF DOWNLOAD
Description
Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up – PDF DOWNLOAD
FILE DETAILS:
Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up – PDF DOWNLOAD
Language : English
Pages : 13
Downloadable : Yes
File Type : PDF
IMAGES PREVIEW OF THE MANUAL:
TABLE OF CONTENTS:
Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up – PDF DOWNLOAD
M6-001-00 Operation and Maintenance Manual with Parts Suppliment 1
Dump Body Supplement 2
Table of Contents 3
Operating Instructions 4
Dump Body Wiring 9
EV-1A Wiring10
Dump Body Components12
DESCRIPTION:
Taylor-Dunn B2-48 Dump Body Operation & Maintenance Parts Manual S.NO.1977 & up – PDF DOWNLOAD
OPERATING INSTRUCTIONS:
General:
This publication is supplemental to the model B2-48 Maintenance, Service, and Parts manual, and covers only the ‘dump body’ portion of the vehicle. It is important that the Introduction and Operating Guidelines sections in the B2-48 Maintenance, Service, and Parts manual, are read and understood before operating any control on the vehicle.
Controls:
- The dump body on the vehicle is raised and lowered hydraulically, but is controlled electrically by means of a pair of push button switched located on the left rear panel of the vehicle. Depressing the top push-button starts the 12 volt hydraulic motor, which supplies pressurized fluid to the hydraulic cylinder, and raises the dump body. When the cylinder reaches full travel (dump body fully elevated), a relief valve in the pump unit opens at a factory pre-set pressure of 2,000 psi. Fluid is then returned to the pump tank.
- At any point prior to the fully elevated position, if the push button is released, the dump body will hold at the position where the switch was released due to a one way check valve, which prevents fluid from returning through the pump to the tank.
- To lower the dump body, press the bottom button and the solenoid valve opens allowing fluid to return to the tank at a specified rate. At any point during the lowering of the dump body, if the push button is released, the solenoid valve closes and the dump body will hold its position where the switch was released.
G.B 25/01/25
