Tigercat 724D FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

Description

Tigercat 724D FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

DESCRIPTION:

Tigercat 724D FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

INTRODUCTION :

• An Operator’s manual, Service manual and a Parts catalog are made available by Tigercat to assist the
  dealer, customer and operator in becoming familiar with the features of the 724D Feller Buncher.
• The operator’s manual will assist the operator with the techniques of proper and safe operation of the
  724D Feller Buncher. There is also important information regarding the safe operation of the saw head.
  The service manual contains safety and servicing procedures and a preventive maintenance schedule to
  ensure optimum machine performance.
• Section 1 in both the operator’s manual and the service manual contains safety information that must be
  followed. As well, throughout the rest of the manuals, WARNING and CAUTION notices are displayed
  where necessary, drawing attention to possible hazards when performing certain procedures.
• Only trained personnel should be allowed to operate or work on the machine.
• The information contained in this manual is current at time of printing. Improvements to the machine are
  on going and may not be covered, therefore in these cases contact your Tigercat dealer for the
  appropriate information.
• The phrase “and up” appearing in this manual after the serial number implies that the related
  information is current for any machine serial number HIGHER than the serial number preceding the “and
  up”.
• Tigercat reserves the right to make changes to the machine after this manual release date that may not
  immediately appear in this manual.

TABLE OF CONTENTS:

Tigercat 724D FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

724D OPERATOR’S ISSUE 2.1…………………………….. 1
INTRODUCTION…………………………………….. 3
S.A.E. STANDARDS…………………………………. 4
NON-APPROVED FIELD PRODUCT CHANGES…………………. 5
SECTION 1 – SAFETY…………………………………… 7
ARTICULATION LOCK BAR ……………………………. 17
BOOM LIFT LOCK ………………………………….. 17
ENGINE ACCESS PANELS …………………………….. 18
FELLING TREES …………………………………… 13
FIRE PREVENTION …………………………………. 18
FIRE PREVENTION GUIDELINES ……………………. 19
WHAT ELSE TO DO BEFORE YOU EXPERIENCE A FIRE ……. 20
WHAT TO DO AFTER A FIRE ………………………. 21
WHAT TO DO IN CASE OF A MACHINE FIRE …………… 20
PARKING THE MACHINE ……………………………… 14
SAFETY INTERLOCK SWITCHES ON CAB DOORS …………….. 15
SAFETY PRECAUTIONS, GENERAL ………………………. 9
SAFETY PRECAUTIONS, OPERATING …………………….. 12
SAFETY PRECAUTIONS, SERVICING …………………….. 16
SAFETY SYMBOLS ………………………………….. 8
USING HIGH SPEED DISC SAWS SAFELY……………………… 23
Comments and instructions…………………………. 23
Direction of throw …………………………… 29
High angle wrist rotation ability ……………… 30
Recognizing the Dangers ………………………. 29
Throwing long wood pieces …………………….. 32
Dangers ………………………………………… 25
forward ………………………………………… 24
Be aware of the hazards ………………………. 24
Other instructions …………………………… 25
Safe practices ………………………………. 25
Several types of heads involved ……………….. 24
Stored energy ……………………………….. 24
HIGH ANGLE WRIST ROTATION CAPABILITY ………………. 31
Saw Head Don’ts …………………………………. 37
Type of Housing makes a Difference ………………… 26
SECTION 2 – CONTROLS AND OPERATION…………………….. 39
ACCUMULATING ARMS ……………………………….. 40
AIR CLEANER, ENGINE AIR ………………………….. 61
AIR CLEANER UNLOADER VALVE ……………………….. 61
AIR CONDITIONER/HEATER …………………………… 46
AIR VENTS ………………………………………. 46
ARTICULATION LOCK BAR ……………………………. 77
AUXILIARY POWER OUTLET …………………………… 56
AUXILIARY SWITCH LOCATION ………………………… 55
BATTERY DISCONNECT SWITCH ………………………… 58
BOOM CYLINDER LOCK ………………………………. 78
Boom Lift ………………………………………. 40
BRAKES …………………………………………. 41
BULB TEST/ENGINE SHUTDOWN OVERRIDE – SWITCH ……… 54
CARE OF THE MACHINE ……………………………… 72
CENTER JOINT LOCK PIN ……………………………. 77
CIGAR LIGHTER …………………………………… 56
Clamp arms ……………………………………… 41
CLEANING A/C CONDENSER AND COOLING ASSEMBLY ……… 62
CLEANING LEXAN WINDOWS …………………………… 73
CONTROLS – CAB ………………………………….. 40
CREEP SWITCH ……………………………………. 52
DIFFERENTIAL LOCK, (FRONT) SWITCH …………………. 40
DIFFERENTIAL LOCK, (REAR) SWITCH ………………….. 52
DRIVE 1-2-3 -SWITCH ……………………………… 53
DRIVE CONTROL …………………………………… 40
EMERGENCY EXIT/SKYLIGHT ………………………….. 44
ENGINE ACCESS PANELS …………………………….. 58
ENGINE AIR PRECLEANER ……………………………. 60
ENGINE COMPARTMENT ………………………………. 58
ENGINE, HOT WATER SHUT OFF VALVE ………………….. 47
ENGINE, RESTARTING AFTER RUNNING OUT OF FUEL ……… 68
ENGINE RPM ……………………………………… 41
ENGINE, STARTING ………………………………… 68
ENGINE, STARTING IN COLD WEATHER ………………….. 69
ENGINE, STOPPING ………………………………… 71
ETHER STARTING AID (OPTIONAL) ……………………. 69
FAN SWITCH ……………………………………… 54
FILTER – CAB FRESH AIR …………………………… 47
FILTER, RECIRCULATING AIR – A/C UNIT ………………. 46
FOOT CONTROL, CENTER …………………………….. 41
FOOT CONTROL, LEFT ………………………………. 41
FOOT CONTROL, RIGHT ……………………………… 40
FUEL TANK ………………………………………. 59
FUSE PANEL ……………………………………… 56
GAUGES………………………………………….. 39
ENGINE COOLANT TEMPERATURE ……………………. 50
ENGINE OIL PRESSURE ………………………….. 50
HYDRAULIC OIL TEMPERATURE …………………….. 50
TACHOMETER ………………………………….. 50
VOLTMETER …………………………………… 50
GEAR SHIFT LEVER ………………………………… 43
Head tilt ………………………………………. 40
HORN SWITCH …………………………………….. 51
HOT WATER SHUT OFF VALVE (ENGINE) …………………. 47
HOURMETER ………………………………………. 56
HYDRAULIC HAND FILL PUMP …………………………. 60
HYDRAULIC OIL RESERVOIR ………………………….. 59
INSTRUMENT PANEL ………………………………… 48
JOYSTICK, LEFT ………………………………….. 40
JOYSTICK, RIGHT …………………………………. 40
KEY SWITCH ……………………………………… 55
LIGHT – DOME ……………………………………. 44
LIGHTER ………………………………………… 56
LIGHTS SWITCH, WORKING, REAR …………………….. 48
LIGHTS SWITCH, WORKING, FRONT …………………….. 48
MACHINE PREPARATION ……………………………… 70
System Test and Warm-Up ………………………. 70
OPERATING MACHINE ……………………………….. 64
PRE-START CHECKS …………………………….. 64
PARKING BRAKE …………………………………… 42
PILOT RESET SWITCH ………………………………. 51
PILOT SYSTEM SHUT OFF ……………………………. 51
PRECLEANER, ENGINE AIR …………………………… 60
PRESSURIZED WATER SYSTEM …………………………. 44
RADIO, AM/FM STEREO CASSETTE ……………………… 44
SAW CIRCUIT PRESSURE – GAUGE ……………………… 57
SAW SWITCH ……………………………………… 51
SEAT …………………………………………… 44
SKYLIGHT/EMERGENCY EXIT ………………………….. 44
SPEED CONTROL LEVER ……………………………… 42
STARTING ENGINE …………………………………. 68
STEREO CASSETTE/RADIO ……………………………. 44
STOPPING ENGINE …………………………………. 71
THROTTLE CONTROL ………………………………… 41
TOWING INSTRUCTIONS ……………………………… 74
TRANSPORTING INSTRUCTIONS ………………………… 76
VACUUM PUMP (OPTIONAL – EARLIER) ………………….. 56
WARNING LIGHTS…………………………………… 39
COOLANT LEVEL ……………………………….. 48
COOLANT TEMPERATURE ………………………….. 48
ENGINE OIL PRESSURE ………………………….. 48
HYDRAULIC OIL TEMPERATURE …………………….. 49
LOW HYDRAULIC OIL LEVEL ………………………. 49
WATER SYSTEM, PRESSURIZED ……………………….. 44
SECTION 3 – LUBRICATION & MAINTENANCE………………….. 79
AIR CLEANER MAINTENANCE ………………………….. 92
AIR CONDITIONING SYSTEM, CHECKING …………………. 96
BELT, ENGINE SERPENTINE, REPLACING …………………101
CENTER JOINT…………………………………….. 97
LUBRICATION …………………………………. 97
MAINTENANCE …………………………………. 97
DRIVE SHAFT SPLINE LUBRICATION, MIDDLE AND REAR ……..102
EMERGENCY EXITS, CHECK MONTHLY ……………………. 81
ENGINE SERPENTINE BELT, REPLACING ………………….101
FILTERS…………………………………………. 79
ENGINE AIR CLEANER …………………………… 92
FUEL FILTER/WATER SEPARATOR …………………… 88
FUEL TANK STRAINER …………………………… 89
HYDRAULIC OIL RETURN FILTERS ………………….. 90
HYDROSTATIC CHARGE PUMP PRESSURE FILTERS ………. 90
FIRE PREVENTION …………………………………. 81
HYDRAULIC OILS ………………………………….. 85
NEW MACHINE MAINTENANCE…………………………… 79
FIRST 50-100 HOUR INSPECTION AND SERVICE REPORT …. 80
INITIAL PRE-DELIVERY INSPECTION ……………….. 80
TIGHTENING POINTS ……………………………. 80
OIL LOST FROM LEAKAGE ……………………………. 80
PRESSURE SETTINGS ………………………………..107
PRESSURIZED WATER SYSTEM MAINTENANCE ………………. 94
REPLACING THE ENGINE SERPENTINE BELT ……………….101
SCHEDULED MAINTENANCE…………………………….. 79
GENERAL …………………………………….. 81
8 HOURS …………………………………….. 82
125 HOURS …………………………………… 83
250 HOURS …………………………………… 83
500 HOURS …………………………………… 84
1000 HOURS ………………………………….. 84
2000 HOURS ………………………………….. 84
SEASONAL ……………………………………. 85
SERVICE AND LUBRICATION POINTS CHART ………………. 86
SPEED CONTROL LEVER ADJUSTMENT …………………….104
STARTUP PROCEDURE AFTER MAINTENANCE ……………….. 98
TORQUE CHART …………………………………….105
TORQUE CHART, GENERAL …………………………….106
TRANSMISSION ……………………………………. 97
CHECK OIL LEVEL ……………………………… 97
WHEELS, INSTALLING ………………………………. 80

IMAGES PREVIEW OF THE MANUAL:

PLEASE NOTE:

• This is the same manual used by the DEALERSHIPS to SERVICE your vehicle.
• The manual can be all yours – Once payment is complete, you will be taken to the download page from where you can download the manual. All in 2-5 minutes time!!
• Need any other service / repair / parts manual, please feel free to contact us at [email protected] . We may surprise you with a nice offer

S.V