Tigercat 845 FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

Description

Tigercat 845 FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

DESCRIPTION:

Tigercat 845 FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

INTRODUCTION :

• An Operator’s manual, Service manual and a Parts catalog are made available by Tigercat to assist the
  dealer, customer and operator in becoming familiar with the features of the 845 Feller Buncher
  Serial number 8450101 to 8450475.
• The operator’s manual will assist the operator with the techniques of proper and safe operation of the 845
  Feller Buncher. There is also important information regarding the safe operation of the saw head. The
  service manual contains safety and servicing procedures and a preventive maintenance schedule to
  ensure optimum machine performance.
• Section 1 in both the operator’s manual and the service manual contains safety information that must be
  followed. As well, throughout the rest of the manuals WARNING and CAUTION notices are displayed
  where necessary, drawing attention to possible hazards when performing certain procedures.
• Only trained personnel should be allowed to operate or work on the machine.
• The information contained in this manual is current at time of printing. Improvements to the machine are
  on-going and may not be covered, therefore in these cases contact your Tigercat dealer for the
  appropriate information.

TABLE OF CONTENTS:

Tigercat 845 FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD

845 OPERATOR’S – ISSUE 3.1………………………………….. 1
INTRODUCTION…………………………………………… 3
NON-APPROVED FIELD PRODUCT CHANGES……………………….. 4
GENERAL SPECIFICATIONS………………………………….. 5
SECTION 1 – SAFETY…………………………………………. 7
battery disconnect switch ……………………………….12
cooling system …………………………………………13
exhaust fumes ………………………………………….14
FIRE PREVENTION………………………………………… 7
FIRE PREVENTION GUIDELINES …………………………..15
WHAT ELSE TO DO BEFORE YOU EXPERIENCE A FIRE …………..16
WHAT TO DO AFTER A FIRE ……………………………..17
WHAT TO DO IN CASE OF A MACHINE FIRE ………………….16
first aid ……………………………………………..10
Fluid leaks ……………………………………………13
Hydraulic Pressure hazard ……………………………….13
loose clothing hazard …………………………………..14
Parking hazards ………………………………………..12
protective clothing ……………………………………. 9
SAFETY PRECAUTIONS, GENERAL …………………………….. 9
SAFETY PRECAUTIONS, OPERATING ……………………………11
SAFETY PRECAUTIONS, SERVICING ……………………………13
SAFETY SYMBOLS ………………………………………… 8
Signal Words ………………………………………….. 8
APPENDIX – USING HIGH SPEED DISC SAWS SAFELY…………………..19
Comments and instructions………………………………..19
Direction of throw ………………………………….25
High angle wrist rotation ability …………………….26
Recognizing the Dangers ……………………………..25
Throwing long wood pieces ……………………………28
Dangers ……………………………………………….21
forward ……………………………………………….20
Be aware of the hazards ……………………………..20
Other instructions ………………………………….21
Safe practices ……………………………………..21
Several types of heads involved ………………………20
Stored energy ………………………………………20
HIGH ANGLE WRIST ROTATION CAPABILITY ……………………..27
Saw Head Don’ts ………………………………………..33
Type of Housing makes a Difference ……………………….22
SECTION 2 – CONTROLS & OPERATION……………………………..35
CONTROLS – CAB, Serial No. 8450101 to 8450465………………35
AIR CONDITIONER/HEATER …………………………….43
AM/FM STEREO CASSETTE ……………………………..42
Anti-Stall ……………………………………….40
CIRCUIT BREAKERS ………………………………….38
Clamp Arms SWITCH …………………………………37
Dome light ……………………………………….42
EMERGENCY EXITS …………………………………..42
Engine Coolant Temperature …………………………39
Engine Oil Pressure ……………………………….39
Engine RPM ……………………………………….41
Ether Starting Aid switch (OPTIONAL) ………………..40
FAN ……………………………………………..42
Filter Bypass …………………………………….38
FOOT PEDAL, LEFT ………………………………….37
FOOT PEDAL, RIGHT …………………………………37
FUEL GAUGE ……………………………………….39
HEATER/AIR CONDITIONER …………………………….43
Horn, SWITCH ……………………………………..37
Hour meter ……………………………………….41
Hydraulic Oil Low …………………………………38
Hydraulic Oil Temperature ………………………….39
Ignition switch …………………………………..40
JOYSTICK, L. H. …………………………………..37
JOYSTICK, R. H. …………………………………..37
Low Coolant ………………………………………38
Low/drive switch ………………………………….40
Main boom ………………………………………..37
Pilot reset ………………………………………41
Pilot system shut off ……………………………..41
Pump Inlet ……………………………………….38
REAR WINDOW/EMERGENCY EXIT …………………………43
Saw On LIGHT ……………………………………..38
Saw switch ……………………………………….39
Service lights ……………………………………42
SKYLIGHT/EMERGENCY EXIT ……………………………42
Steering …………………………………………37
STEREO CASSETTE …………………………………..42
Stick BOOM ……………………………………….37
Swing ……………………………………………37
Swing Brake ………………………………………39
THROTTLE CONTROL ………………………………….41
Tilt …………………………………………….37
Travelling ……………………………………….37
Voltmeter ………………………………………..39
Work lights ………………………………………42
Wrist SWITCH ……………………………………..37
CONTROLS – CAB, Serial No. 8450466 to 8450475………………35
Accumulating Arms SWITCH …………………………..45
AIR CONDITIONER/HEATER …………………………….53
ALARM OVERRIDE SWITCH ……………………………..50
AM/FM STEREO CASSETTE ……………………………..52
Anti-Stall ……………………………………….49
BULB TEST SWITCH ………………………………….47
CIGAR/CIGARETTE LIGHTER ……………………………50
CIRCUIT BREAKERS ………………………………….46
Clamp Arms ……………………………………….45
DIMMER control ……………………………………47
Dome light ……………………………………….52
drive SWITCH ……………………………………..49
EMERGENCY EXITS …………………………………..52
Engine Coolant Temperature …………………………48
Engine RPM ……………………………………….51
Ether Starting Aid switch (OPTIONAL) ………………..50
FAN ……………………………………………..52
Filter Bypass …………………………………….47
FOOT PEDAL, LEFT ………………………………….46
FOOT PEDAL, RIGHT …………………………………46
FUEL LEVEL ……………………………………….48
HEATER/AIR CONDITIONER …………………………….53
Horn SWITCH ………………………………………45
Hour meter ……………………………………….48
Hydraulic Oil Low …………………………………46
Hydraulic Oil Temperature ………………………….48
Ignition switch …………………………………..50
JOYSTICK, L.H. ……………………………………45
JOYSTICK, R.H. ……………………………………45
Low Coolant ………………………………………47
Low/drive SWITCH ………………………………….49
Main boom ………………………………………..45
Pilot reset ………………………………………50
Pilot system shut off ……………………………..51
Pump Inlet ……………………………………….47
REAR WINDOW/EMERGENCY EXIT …………………………53
Saw SWITCH ……………………………………….48
Service lights ……………………………………52
SKYLIGHT/EMERGENCY EXIT ……………………………52
Steering …………………………………………46
STEREO CASSETTE …………………………………..52
Stick BOOM ……………………………………….45
Swing ……………………………………………45
Swing Brake ………………………………………51
Tachometer ……………………………………….47
THROTTLE CONTROL ………………………………….51
Tilt …………………………………………….45
Travelling ……………………………………….46
TREE COUNTER ……………………………………..47
Voltmeter ………………………………………..48
Wrist ……………………………………………45
DEBRIS SCREEN ………………………………………..72
engine AIR CLEANER ……………………………………70
engine AIR CLEANER UNLOADER VALVE ………………………70
ENGINE AIR PRECLEANER …………………………………70
ENGINE COMPARTMENT ……………………………………65
ENGINE, RESTARTING AFTER RUNNING OUT OF FUEL ………..76
ENGINE, STARTING ……………………………………..76
ENGINE, STARTING IN COLD WEATHER ……………………….77
ENGINE, STOPPING ……………………………………..79
FELLING HEAD …………………………………………79
FILTER, FRESH AIR – A/C UNIT …………………………..55
Filter restriction gauge ………………………………66
FIRE SUPPRESSION SYSTEM (optional)………………………..36
CONTROL BOX ………………………………………58
IN CASE OF FIRE …………………………………..59
INSPECTION ……………………………………….59
KIDDE FIRE SUPPRESSION SYSTEM ………………………60
PREDELIVERY INSPECTION …………………………….60
THERMOSTATS AND NOZZLES ……………………………58
FUEL LEVEL SENDER …………………………………….65
FUEL TANK ……………………………………………65
HOT WATER SHUT OFF VALVE (ENGINE) ………………………55
HYDRAULIC HAND FILL PUMP ………………………………69
HYDRAULIC OIL HEATER (OPTIONAL) ………………………..67
HYDRAULIC OIL RESERVOIR ……………………………….66
HYDRAULIC pressurization system ………………………..68
HYDRAULIC TANK………………………………………….36
To pressurize tank ………………………………..69
LEXAN WINDOWS CLEANING INSTRUCTIONS …………………….80
MACHINE PREPARATION …………………………………..77
System Test and Warm-Up ……………………………77
OPERATING MACHINE …………………………………….74
OPERATING TIPS WITH LOAD SENSING ……………………….78
Pre-Start Checks ……………………………………..74
PRECLEANER, ENGINE AIR ………………………………..70
RAD., A/C COND. & OIL COOLER ~ CLEANING ………………..72
rad/oil cooler cleanout access panels …………………..72
REAR WINDOW/SKYLIGHT INSTALLATION ………………………61
RETURN FILTERS ~ HYDRAULIC OIL …………………………66
saw head. See saw head manufacturers manual………………..36
saw head safety. See saw head safety section in this manual….36
SEAT ………………………………………………..56
Seat,operating and adjusting …………………………..56
SKYLIGHT AND REAR WINDOW INSTALLATION …………………..61
STARTING ENGINE ………………………………………76
STARTING IN COLD WEATHER ………………………………77
STOPPING ENGINE ………………………………………79
SUCTION STRAINERS ~ HYDRAULIC OIL ………………………67
switch, Battery Disconnect …………………………….65
System Test and Warm-Up ……………………………….77
taking CARE OF THE MACHINE …………………………….79
Travelling …………………………………………..78
VENT, HYDRAULIC OIL RESERVOIR ………………………….69
SECTION 3 – LUBRICATION & MAINTENANCE…………………………81
FILTER AND LUBRICATION SCHEDULE ………………………….87
FIRST 100 HOURS ………………………………………..82
FIRST 25 HOURS …………………………………………82
GENERAL MAINTENANCE …………………………………….83
HYDRAULIC OILS …………………………………………86
LUBRICATION SCHEDULE ……………………………………87
NEW MACHINE MAINTENANCE …………………………………82
THE FIRST 100 HOURS …………………………………82
THE FIRST 25 HOURS ………………………………….82
PRESSURE SETTING PROCEDURES. See SERVICE MANUAL…………….81
PRESSURE SETTING VALUES. See SERVICE MANUAL, SECTION 4………81
PREVENTIVE MAINTENANCE SCHEDULE ………………………….82
SCHEDULED MAINTENANCE……………………………………81
125 HOURS ………………………………………….84
24 HOURS: ………………………………………….84
250 HOURS ………………………………………….85
500 HOURS: …………………………………………85
8 HOURS: …………………………………………..84
TIGHTENING POINTS ………………………………………82
TORQUE CHART, GENERAL …………………………………..89
TORQUE SETTINGS, RECOMMENDED …………………………….88

IMAGES PREVIEW OF THE MANUAL:

TIGERCAT 845 FELLER BUNCHER OPERATOR’S MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the SAME exact manual used by your dealers to fix your vehicle.
• The same can be yours in the next 2-3 mins as you will be directed to the download page immediately after paying for the manual.
• Any queries / doubts regarding your purchase, please feel free to contact [email protected]

S.V