Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

Description

Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

DESCRIPTION:

Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

INTRODUCTION :

• An Operator’s manual, Service manual and a Parts catalog are made available by Tigercat to assist the
  dealer, customer and operator in becoming familiar with the features of the M760 Mulcher serial number
  760M0101 TO 760M0180.
• The operator’s manual will assist the operator with the techniques of proper and safe operation of the M760
  Mulcher. There is also important information regarding the safe operation of the mulching head. The
  service manual contains safety and servicing procedures and a preventive maintenance schedule to
  ensure optimum machine performance.
• Section 1 in both the operator’s manual and the service manual contains safety information that must be
  followed. As well, throughout the rest of the manuals, WARNING and CAUTION notices are displayed
  where necessary, drawing attention to possible hazards when performing certain procedures.
• Only trained personnel should be allowed to operate or work on the machine.
• The information contained in this manual is current at time of printing. Improvements to the machine are
  on-going and may not be covered, therefore in these cases contact your Tigercat dealer for the
  appropriate information.
• The phrase “and up” appearing in this manual after the serial number implies that the related information
  is current for any machine serial number HIGHER than the serial number preceding the “and up”.
• Tigercat reserves the right to make changes to the machine after this manual release date that may not
  immediately appear in this manual.

TABLE OF CONTENTS:

Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

M760 OPERATOR ISSUE 2.0 (760M0101-760M0180)………….. 1
INTRODUCTION………………………………….. 3
S.A.E. STANDARDS………………………………. 4
NON-APPROVED FIELD PRODUCT CHANGES………………. 5
SECTION 1 – SAFETY………………………………… 7
ARTICULATION LOCK BAR …………………………. 20
BOOM LIFT LOCK ……………………………….. 20
CAB EXITS ……………………………………. 15
EMERGENCY CAB EXITS …………………………… 15
ENGINE ACCESS PANELS ………………………….. 18
FIRE PREVENTION ………………………………. 22
FIRE PREVENTION GUIDELINES …………………. 22
WHAT ELSE TO DO BEFORE YOU EXPERIENCE A FIRE …. 23
WHAT TO DO AFTER A FIRE ……………………. 24
WHAT TO DO IN CASE OF A MACHINE FIRE ………… 23
HAZARD ZONE ………………………………….. 9
MULCHING OPERATION SAFETY ……………………… 16
PARKING THE MACHINE …………………………… 14
SAFETY INTERLOCK SWITCHES ON CAB DOORS ………….. 15
SAFETY PRECAUTIONS, GENERAL ……………………. 8
SAFETY PRECAUTIONS, OPERATING ………………….. 12
SAFETY PRECAUTIONS, SERVICING ………………….. 18
SAFETY SYMBOLS ……………………………….. 8
SIGNAL WORDS …………………………………. 8
APPENDIX – USING HIGH SPEED DISC SAWS SAFELY…………. 25
Comments and instructions………………………. 25
Direction of throw ………………………… 31
High angle wrist rotation ability …………… 32
Recognizing the Dangers ……………………. 31
Throwing long wood pieces ………………….. 34
Dangers ……………………………………… 27
forward ……………………………………… 26
Be aware of the hazards ……………………. 26
Other instructions ………………………… 27
Safe practices ……………………………. 27
Several types of heads involved …………….. 26
Stored energy …………………………….. 26
HIGH ANGLE WRIST ROTATION CAPABILITY ……………. 33
Saw Head Don’ts ………………………………. 39
Type of Housing makes a Difference ……………… 28
SECTION 2 – CONTROLS AND OPERATION………………….. 41
AIR COMPRESSOR ……………………………….. 46
AIR CONDITIONER/HEATER ………………………… 49
air supply connector ………………………….. 46
AIR VENTS ……………………………………. 49
ARTICULATION LOCK BAR …………………………. 72
Attachment tilt ………………………………. 42
AUXILIARY POWER ………………………………. 56
Battery Disconnect – Switch ……………………. 62
Boom Lift ……………………………………. 42
BRAKE FOOT PEDAL ……………………………… 43
CARE OF THE MACHINE …………………………… 71
CONTROL POD ON ARMREST, R.H…………………….. 59
CONTROLS – CAB ……………………………….. 42
CONTROLS AND INSTRUMENTS ………………………. 76
CUTTER ………………………………………. 56
cutter Circuit Pressure – Gauge ………………… 57
DIFFERENTIAL LOCK, (FRONT) SWITCH ………………. 42
DIFFERENTIAL LOCK, (REAR) SWITCH ……………….. 54
DISPLAY DIAGNOSTIC – green light ……………….. 52
display scroll ……………………………….. 53
DISPLAY WARNING – red light ……………………. 52
EMERGENCY EXIT/SKYLIGHT ……………………….. 46
ems …………………………………………. 53
ENGINE AIR CLEANER ……………………………. 65
ENGINE AIR PRECLEANER …………………………. 64
ENGINE COMPARTMENT ……………………………. 62
ENGINE, HOT WATER SHUT OFF VALVE ……………….. 51
Engine monitoring system (ems) …………………. 53
ENGINE RPM …………………………………… 44
engine, starting ……………………………… 68
ENGINE, STARTING, COLD WEATHER………………….. 41
CUMMINS QSL9 ……………………………… 68
ENGINE, STARTING IN COLD WEATHER ……………….. 68
ENGINE, STOPPING ……………………………… 70
FAN SWITCH …………………………………… 54
FILTER – CAB FRESH AIR ………………………… 50
FILTER, RECIRCULATING AIR – A/C UNIT ……………. 49
FIRE SUPPRESSION SYSTEM………………………… 41
OPERATION ………………………………… 58
FOOT PEDAL……………………………………. 41
BRAKE ……………………………………. 43
FORWARD TRAVEL SPEED ………………………. 43
REVERSE TRAVEL SPEED ……………………… 43
foot rest ……………………………………. 43
FUEL TANK ……………………………………. 62
FUSE AND RELAY COMPARTMENT …………………….. 75
Horn ………………………………………… 57
HYDRAULIC FILTER BYPASS ……………………….. 52
HYDRAULIC HAND FILL PUMP ………………………. 63
HYDRAULIC OIL RESERVOIR ……………………….. 62
Ignition …………………………………….. 55
INSTRUMENT PANEL ……………………………… 52
JOYSTICK, LEFT ……………………………….. 42
JOYSTICK, RIGHT ………………………………. 42
LIFT BOOM CYLINDER LOCK ……………………….. 74
LIGHT – DOME …………………………………. 46
LIGHTER ……………………………………… 56
LOW HYDRAULIC OIL LEVEL, red light ……………… 52
MACHINE PREPARATION …………………………… 69
MULCH DEFLECTOR DOOR ………………………….. 42
OPERATING MACHINE …………………………….. 66
PARKING BRAKE ………………………………… 45
PILOT RESET ………………………………….. 57
PILOT SYSTEM SHUT OFF …………………………. 57
Pre-Start Checks ……………………………… 66
Pressure Gauge, cutter Circuit …………………. 57
PRESSURIZED WATER SYSTEM ………………………. 45
RADIO, AM/FM STEREO CASSETTE …………………… 46
SEAT ………………………………………… 47
SKYLIGHT/EMERGENCY EXIT ……………………….. 46
SPEED CONTROL LEVER …………………………… 44
starting engine ………………………………. 68
STEERING …………………………………….. 42
STEERING WHEEL ……………………………….. 43
STEREO CASSETTE/RADIO …………………………. 46
STOPPING ENGINE ………………………………. 70
System Test and Warm-Up ……………………….. 69
THROTTLE CONTROL ……………………………… 44
TILT STEERING COLUMN ………………………….. 43
TOWING INSTRUCTIONS …………………………… 72
TRANSPORTING INSTRUCTIONS ……………………… 72
WATER SYSTEM, PRESSURIZED …………………….. 45
SECTION 3 – LUBRICATION & MAINTENANCE……………….. 77
AIR CONDITIONING SYSTEM, CHECKING ………………. 92
APPROVED HYDRAULIC OILS ……………………….. 83
BELT, ENGINE SERPENTINE, REPLACING ……………… 97
CENTER JOINT………………………………….. 93
LUBRICATION ………………………………. 93
MAINTENANCE ………………………………. 93
DRIVE SHAFT SPLINE LUBRICATION,…………………. 77
MIDDLE AND REAR …………………………… 98
ELECTRICAL SCHEMATIC…………………………… 77
SHEET 1 OF 6 ………………………………103
SHEET 2 OF 6 ………………………………104
SHEET 3 OF 6 ………………………………105
SHEET 4 OF 6 ………………………………106
SHEET 5 OF 6 ………………………………107
SHEET 6 OF 6 ………………………………108
ENGINE MAINTENANCE CHART ………………………. 86
ENGINE SERPENTINE BELT, REPLACING ………………. 97
FILTERS………………………………………. 77
CHARGE PUMP PRESSURE FILTER ……………….. 88
FUEL FILTER/WATER SEPARATOR ………………… 87
FUEL TANK STRAINER ………………………… 87
HYDRAULIC OIL RETURN FILTERS ……………….. 89
SERVICING GUIDELINES……………………….. 77
OIL FILTERS …………………………… 89
HYDRAULIC OILS, APPROVED ………………………. 83
LUBRICATION AND SERVICE POINTS CHART ……………. 85
MACHINE START-UP ……………………………… 95
MAINTENANCE, GENERAL ………………………….. 79
NEW MACHINE MAINTENANCE………………………… 77
FIRST 8 HOURS …………………………….. 78
FIRST 125 HOURS:~ …………………………. 78
PRESSURE/SPEED SETTINGS ………………………..109
PRESSURIZED WATER SYSTEM……………………….. 77
MAINTENANCE ………………………………. 90
REPLACING ENGINE SERPENTINE BELT ……………….. 97
SCHEDULED MAINTENANCE………………………….. 77
GENERAL ………………………………….. 79
8 HOURS ………………………………….. 80
40 HOURS …………………………………. 80
125 HOURS ………………………………… 81
250 HOURS ………………………………… 81
500 HOURS ………………………………… 82
1000 HOURS ……………………………….. 82
2000 HOURS ……………………………….. 82
SEASONAL …………………………………. 83
SPEED CONTROL LEVER ADJUSTMENT ………………….100
START-UP …………………………………….. 95
STARTUP PROCEDURE……………………………… 77
AFTER MAINTENANCE …………………………. 94
TIGHTENING POINTS …………………………….. 78
TORQUE CHART ………………………………….101
TORQUE SPECIFICATIONS – GENERAL …………………102
TRANSMISSION …………………………………. 93
CHECK OIL LEVEL …………………………… 93
WHEELS, INSTALLING ……………………………. 78

IMAGES PREVIEW OF THE MANUAL:

TIGERCAT M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the same manual used by the dealers to diagnose and troubleshoot your vehicle
• You will be directed to the download page as soon as the purchase is completed. The whole payment and downloading process will take anywhere between 2-5 minutes
• Need any other service / repair / parts manual, please feel free to contact [email protected] . We still have 50,000 manuals unlisted

S.V