Caterpillar C-10 & C-12 Truck Engines Specifications Manual – PDF DOWNLOAD

Description

Caterpillar C-10 & C-12 Truck Engines Specifications Manual – PDF DOWNLOAD

IMAGES PREVIEW OF THE MANUAL:

DESCRIPTION:

Caterpillar C-10 & C-12 Truck Engines Specifications Manual – PDF DOWNLOAD

MBJ1-Up (Engine)
MBL1-Up (Engine)

Important Safety Information :

Most accidents that involve product operation, maintenance and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills and tools to perform these functions properly.

• Improper operation, lubrication, maintenance or repair of this product can be dangerous and could result in injury or death. Do not operate or perform any lubrication, maintenance or repair on this product, until you have read and understood the operation, lubrication, maintenance and repair information.
• Safety precautions and warnings are provided in this manual and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons.
• The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal Word” such as “DANGER”, “WARNING” or “CAUTION”. The Safety Alert “WARNING” label is shown below.

TABLE OF CONTENTS:

Caterpillar C-10 & C-12 Truck Engines Specifications Manual – PDF DOWNLOAD

Specifications Section
Engine Design 4
Engine Design 4
Fuel Transfer Pump 5
Fuel Lines 5
Fuel Filter and Water Separator 6
Fuel Priming Pump and Primary Fuel Filter 6
Electronic Unit Injector 6
Electronic Unit Injector Mechanism 7
Electronic Unit Injector Rocker Arm 7
Electronic Unit Injector Wiring 8
Lifter Group 8
Rocker Shaft 9
Valve Mechanism 9
Valve Mechanism Cover 9
Cylinder Head Valves 10
Cylinder Head 12
Compression Brake 13
Turbocharger 14
Wastegate Solenoid 20
Inlet Manifold 20
Exhaust Manifold 20
Camshaft 21
Engine Oil Filter Base (166-1329 Oil Filter
Base) 21
Engine Oil Cooler 25
Engine Oil Pump 26
Engine Oil Pressure 27
Engine Oil Pan 27
Engine Oil Pan 27
Engine Oil Pan 27
Coolant Conditioner Base 28
Water Temperature Regulator 28
Water Pump 29
Cylinder Block 29
Cylinder Liner 32
Cylinder Liner Projection 32
Crankshaft 32
Crankshaft Seals 33
Vibration Damper and Pulley 33
Connecting Rod Bearing Journal 34
Main Bearing Journal 34
Connecting Rod 34
Connecting Rod 35
Piston and Rings 36
Piston and Rings 37
Piston Cooling Jet 38
Accessory Drive (Air Compressor) 39
Housing (Front) 39
Gear Group (Front) 41
Rear Power Take-Off (RPTO) 42
Flywheel 43
Flywheel 44
Flywheel Housing 44
Flywheel Housing (Rear Power Take-Off
(RPTO)) 45
Engine to Transmission Adapter 45
Belt Tensioner 46
Belt Tensioner 46
Auxiliary Drive Pulley 47
Alternator and Regulator 47
Electric Starting Motor 48
Electric Starting Motor 48
Electric Starting Motor 49
Electrical Ground Stud 50
Coolant Temperature Sensor 50
Fuel Temperature Sensor 50
Engine Oil Pressure Sensor 51
Boost Pressure Sensor 51
Atmospheric Pressure Sensor 51
Speed and Timing Sensor 51
Accelerator Pedal Position Sensor 52
Air Compressor 52
Index Section
Index 53

CATERPILLAR C-10 & C-12 TRUCK ENGINES SPECIFICATIONS MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the same manual used by the DEALERSHIPS to SERVICE your vehicle.
• The manual can be all yours – Once payment is complete, you will be taken to the download page from where you can download the manual. All in 2-5 minutes time!!
• Need any other service / repair / parts manual, please feel free to contact us at heydownloadss @gmail.com . We may surprise you with a nice offer

S.V