Clark Forklift NST245 English O-285 Operator’s Manual

Description

Clark Forklift NST245 English O-285 Operator’s Manual

CLARK FORKLIFT NST245 ENGLISH O-285 OPERATOR’S MANUAL:

Image Preview:

Description:

Clark Forklift NST245 English O-285 Operator’s Manual

• SAFETY INSTRUCTIONS FOR MAINTAINING INDUSTRIAL TRUCKS Powered industrial trucks may becane hazardous if adequate maintenance is neglected. Therefore, adequate maintenance facilities, personnel and procedures should be provided. Maintenance and inspection of all powered industrial trucks should be performed in conformance with the recommendation in this manual and the following practices.
• 1. A scheduled preventive maintenance, lubrication, and inspection system should be followed. 2. Only qualified and authorized personnel should be permitted to maintain, repair, adjust, and inspect industrial trucks. J. Before Leaving The Truck: A. Stop truck. 8, Fully lower the load engaging means. C. Place directional controls in neutral. D, Apply the parking brake.
• E’. Stop the engine or turn off power. F. Lock the control or ignition circuit. G. Block the wheels if truck is on a ramp, or being worked on. 4. Before Working On Truck: A. Raise wheels free of floor or disconnect power source. 8. Use chocks or other positive truck positioning devices. C. Block load engaging means, innermast(s), or chassis before working under them, Before working on engine fuel system of gasoline powered trucks with gravity feed fuel systems, be sure fuel shutoff valve is closed. Before working on engine fuel system of LP gas powered trucks, close LP gas cylinder valve and run engine until fuel in system is depleted and engine stops running.
• Operation to check performance of the truck or attachments should be conducted in an authorized, safe clearance area. 5. Before Starting To Operate The Truck; A. Be in operating position.
• 8. Depress clutch (or brake pedal on automatic transmission and electric trucks). C. Place directional controls in neutral. D. Start engine or turn on power. E. Before operating truck, check functioning of lift and tilt systems, directional and speed controls, steering, warning devices, brakes, and any attachment. (If used) F. Release parking brake.

Table Of Contents:

Clark Forklift NST245 English O-285 Operator’s Manual

Instructions On Use Of Manual
Instructions On Use Of Manual
Table Of Contents
Table Of Contents
Illustration Of Machine
Specifications
Specifications
NS-20 Specifications
NS-30-40 Specifications
NSP-20 Specifications
NSP-30 Specifications
NSP-40 Specifications
0 P E R A T I O N S
Overa l I Controls
Battery Connector Power Key Switch
Combination Drive and Lift-Lower
Control Handle
Battery Charge Indicato r, Hour Meter
Brake and Parking Brake
To pick-up, move and deposit a load.
Safety and Operating Suggestions
To pick-up,–move and deposit a load.
Safety and Operating Suggestions

Please Note:

• This is the SAME exact manual used by your dealers to fix your vehicle.
• The same can be yours in the next 2-3 mins as you will be directed to the download page immediately after paying for the manual.
• Any queries / doubts regarding your purchase, please feel free to contact [email protected]

sk