Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

Description

Tigercat M760 MULCHER OPERATOR’S MANUAL- PDF DOWNLOAD

DESCRIPTION:

Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

INTRODUCTION :

• An Operator’s manual, Service manual and a Parts catalog are made available by Tigercat to assist the
  dealer, customer and operator in becoming familiar with the features of the M760 Mulcher serial number
  760M0181 and up.
• The operator’s manual will assist the operator with the techniques of proper and safe operation of the M760
  Mulcher. There is also important information regarding the safe operation of the mulching head. The
  service manual contains safety and servicing procedures and a preventive maintenance schedule to
  ensure optimum machine performance.
• Section 1 in both the operator’s manual and the service manual contains safety information that must be
  followed. As well, throughout the rest of the manuals, WARNING and CAUTION notices are displayed
  where necessary, drawing attention to possible hazards when performing certain procedures.
• Only trained personnel should be allowed to operate or work on the machine.
• The information contained in this manual is current at time of printing. Improvements to the machine are
  on-going and may not be covered, therefore in these cases contact your Tigercat dealer for the
  appropriate information.
• The phrase “and up” appearing in this manual after the serial number implies that the related information
  is current for any machine serial number HIGHER than the serial number preceding the “and up”.
• Tigercat reserves the right to make changes to the machine after this manual release date that may not
  immediately appear in this manual.

TABLE OF CONTENTS:

Tigercat M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD

M760 OPERATOR ISSUE 2.0 (760M0181 & UP)………………… 1
INTRODUCTION…………………………………….. 3
S.A.E. STANDARDS…………………………………. 4
NON-APPROVED FIELD PRODUCT CHANGES…………………. 5
SECTION 1 – SAFETY…………………………………… 7
ARTICULATION LOCK BAR ……………………………. 20
BATTERY DISCONNECT SWITCH ………………………… 14
BOOM LIFT LOCK ………………………………….. 20
CAB EXITS ………………………………………. 15
EMERGENCY CAB EXITS ……………………………… 15
ENGINE ACCESS PANELS …………………………….. 18
FIRE PREVENTION …………………………………. 24
FIRE PREVENTION GUIDELINES ……………………. 24
WHAT ELSE TO DO BEFORE YOU EXPERIENCE A FIRE ……. 25
WHAT TO DO AFTER A FIRE ………………………. 26
WHAT TO DO IN CASE OF A MACHINE FIRE …………… 25
FLUID INJECTION INJURY …………………………… 22
GREASE INJECTION INJURY ………………………….. 23
HAZARD ZONE …………………………………….. 9
MULCHING OPERATION SAFETY ………………………… 16
PARKING THE MACHINE ……………………………… 14
SAFETY INTERLOCK SWITCHES ON CAB DOORS …………….. 15
SAFETY PRECAUTIONS, GENERAL ………………………. 8
SAFETY PRECAUTIONS, OPERATING …………………….. 12
SAFETY PRECAUTIONS, SERVICING …………………….. 18
SAFETY SYMBOLS ………………………………….. 8
SIGNAL WORDS ……………………………………. 8
USING HIGH SPEED DISC SAWS SAFELY……………………… 27
Comments and instructions…………………………. 27
Direction of throw …………………………… 33
High angle wrist rotation ability ……………… 34
Recognizing the Dangers ………………………. 33
Throwing long wood pieces …………………….. 36
Dangers ………………………………………… 29
forward ………………………………………… 28
Be aware of the hazards ………………………. 28
Other instructions …………………………… 29
Safe practices ………………………………. 29
Several types of heads involved ……………….. 28
Stored energy ……………………………….. 28
HIGH ANGLE WRIST ROTATION CAPABILITY ………………. 35
Saw Head Don’ts …………………………………. 41
Type of Housing makes a Difference ………………… 30
SECTION 2 – CONTROLS AND OPERATION…………………….. 43
AIR COMPRESSOR ………………………………….. 49
AIR CONDITIONER/HEATER …………………………… 54
air supply connector …………………………….. 49
AIR VENTS ………………………………………. 54
ARTICULATION LOCK BAR ……………………………. 77
Attachment tilt …………………………………. 44
AUXILIARY POWER …………………………………. 65
Battery Disconnect – Switch ………………………. 67
Boom Lift ………………………………………. 44
BRAKE FOOT PEDAL ………………………………… 45
CARE OF THE MACHINE ……………………………… 76
CONTROL POD ON ARMREST, R.H……………………….. 81
CONTROLS – CAB ………………………………….. 44
CONTROLS AND INSTRUMENTS …………………………. 88
cutter Circuit Pressure – Gauge …………………… 66
CUTTER SWITCH …………………………………… 58
DISPLAY DIAGNOSTIC – green light ………………….. 57
DISPLAY MODULE ………………………………….. 59
DISPLAY WARNING – red light ………………………. 57
ELECTRICAL CONNECTIONS …………………………… 85
EMERGENCY EXIT/SKYLIGHT ………………………….. 48
ENGINE AIR CLEANER ………………………………. 70
ENGINE AIR PRECLEANER ……………………………. 69
ENGINE COMPARTMENT ………………………………. 67
ENGINE, RESTARTING AFTER RUNNING OUT OF FUEL ……… 73
ENGINE RPM ……………………………………… 62
engine, starting ………………………………… 73
ENGINE, STARTING IN COLD WEATHER ………………….. 74
ENGINE, STOPPING ………………………………… 75
FAN SWITCH ……………………………………… 60
FILTER – CAB FRESH AIR …………………………… 54
FILTER, RECIRCULATING AIR – A/C UNIT ………………. 54
FIRE SUPPRESSION SYSTEM…………………………… 43
OPERATION …………………………………… 80
FOOT PEDAL………………………………………. 43
BRAKE ………………………………………. 45
FORWARD TRAVEL SPEED …………………………. 45
REVERSE TRAVEL SPEED ………………………… 45
foot rest ………………………………………. 45
FUEL TANK ………………………………………. 67
FUSE AND RELAY COMPARTMENT ……………………….. 86
HYDRAULIC FILTER BYPASS ………………………….. 57
HYDRAULIC HAND FILL PUMP …………………………. 68
HYDRAULIC OIL RESERVOIR ………………………….. 67
Ignition ……………………………………….. 65
INSTRUMENT PANEL ………………………………… 56
JOYSTICK, LEFT ………………………………….. 44
JOYSTICK, RIGHT …………………………………. 44
LIFT BOOM CYLINDER LOCK ………………………….. 79
LIGHT – DOME ……………………………………. 48
LIGHTER ………………………………………… 65
LOW HYDRAULIC OIL LEVEL, red light ………………… 57
MACHINE PREPARATION ……………………………… 74
OPERATING MACHINE ……………………………….. 71
PARKING BRAKE …………………………………… 46
PILOT SYSTEM SHUT OFF ……………………………. 61
Pre-Start Checks ………………………………… 71
Pressure Gauge, cutter Circuit ……………………. 66
PRESSURIZED WATER SYSTEM …………………………. 47
RADIO, AM/FM STEREO CD PLAYER …………………….. 48
SEAT …………………………………………… 50
SKYLIGHT/EMERGENCY EXIT ………………………….. 48
SPEED CONTROL LEVER ……………………………… 46
starting engine …………………………………. 73
STEERING ……………………………………….. 44
STEERING WHEEL ………………………………….. 45
STEREO RADIO CD PLAYER …………………………… 48
STOPPING ENGINE …………………………………. 75
System Test and Warm-Up ………………………….. 74
TILT STEERING COLUMN …………………………….. 45
TOWING INSTRUCTIONS ……………………………… 77
TRANSPORTING INSTRUCTIONS ………………………… 77
WARNING LIGHTS…………………………………… 43
ENGINE OIL PRESSURE ………………………….. 57
WATER SYSTEM, PRESSURIZED ……………………….. 47
SECTION 3 – LUBRICATION & MAINTENANCE………………….. 91
AIR CONDITIONING SYSTEM, CHECKING ………………….108
APPROVED HYDRAULIC OILS ………………………….. 99
BELT, ENGINE SERPENTINE, REPLACING …………………113
BLINK CODES ……………………………………..121
CENTER JOINT……………………………………..109
LUBRICATION ………………………………….109
MAINTENANCE ………………………………….109
DRIVE SHAFT SPLINE LUBRICATION, MIDDLE AND REAR ……..114
ELECTRICAL SCHEMATIC……………………………… 91
SHEET 1 ……………………………………..125
SHEET 2 ……………………………………..126
SHEET 3 ……………………………………..127
SHEET 4 ……………………………………..128
ELECTRONIC CONTROLLER BLINK CODES ………………….121
EMERGENCY EXITS, CHECK MONTHLY ……………………. 93
ENGINE MAINTENANCE CHART ………………………….102
ENGINE SERPENTINE BELT, REPLACING ………………….113
FILTERS…………………………………………. 91
CHARGE PUMP PRESSURE FILTER …………………..104
FUEL FILTER/WATER SEPARATOR ……………………103
FUEL TANK STRAINER ……………………………103
HYDRAULIC OIL RETURN FILTERS …………………..105
SERVICING GUIDELINES………………………….. 91
OIL FILTERS ………………………………105
FIRE PREVENTION …………………………………. 93
HYDRAULIC OILS, APPROVED …………………………. 99
LUBRICATION AND SERVICE POINTS CHART ……………….101
MACHINE START-UP …………………………………111
NEW MACHINE MAINTENANCE…………………………… 91
FIRST 8 HOURS ……………………………….. 93
FIRST 125 HOURS:~ ……………………………. 93
FIRST 50-100 HOUR INSPECTION AND SERVICE REPORT …. 92
INITIAL PRE-DELIVERY INSPECTION ……………….. 92
TIGHTENING POINTS ……………………………. 92
OIL LOST FROM LEAKAGE ……………………………. 92
OIL SAMPLE COLLECTION PROCEDURES ………………….. 95
OIL SAMPLING PROGRAM …………………………….. 94
PRESSURE/SPEED SETTINGS …………………………..119
PRESSURIZED WATER SYSTEM………………………….. 91
MAINTENANCE ………………………………….106
REPLACING ENGINE SERPENTINE BELT …………………..113
SCHEDULED MAINTENANCE…………………………….. 91
GENERAL …………………………………….. 93
8 HOURS …………………………………….. 96
40 HOURS ……………………………………. 96
125 HOURS …………………………………… 97
250 HOURS …………………………………… 97
500 HOURS …………………………………… 98
1000 HOURS ………………………………….. 98
2000 HOURS ………………………………….. 98
SEASONAL ……………………………………. 99
SPEED CONTROL LEVER ADJUSTMENT …………………….116
START-UP ………………………………………..111
STARTUP PROCEDURE………………………………… 91
AFTER MAINTENANCE …………………………….110
TORQUE CHART …………………………………….117
TORQUE, FLUID CONNECTIONS …………………………122
TORQUE SPECIFICATIONS – GENERAL ……………………118
TRANSMISSION …………………………………….109
CHECK OIL LEVEL ………………………………109
WHEELS, INSTALLING ………………………………. 92

IMAGES PREVIEW OF THE MANUAL:

TIGERCAT M760 MULCHER OPERATOR’S MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the same manual used by the DEALERSHIPS to SERVICE your vehicle.
• The manual can be all yours – Once payment is complete, you will be taken to the download page from where you can download the manual. All in 2-5 minutes time!!
• Need any other service / repair / parts manual, please feel free to contact us at heydownloadss @gmail.com . We may surprise you with a nice offer

S.V