Tigercat T726E TRENCHER OPERATOR’S MANUAL – PDF DOWNLOAD

Description

Tigercat T726E TRENCHER OPERATOR’S MANUAL – PDF DOWNLOAD

DESCRIPTION:

Tigercat T726E TRENCHER OPERATOR’S MANUAL – PDF DOWNLOAD

INTRODUCTION :

• An Operator’s manual, Service manual and a Parts catalog are made available by Tigercat to assist the
  dealer, customer and operator in becoming familiar with the features of the T726E Trencher serial number
  726T0101 and up.
• The T726E Trencher is designed to cut ground surfaces too hard to cut with bucket-type excavators in
  preparation for digging trenches for laying pipeline, cable or drainage.
• The operator’s manual will assist the operator with the techniques of proper and safe operation of the
  T726E Trencher. There is also important information regarding the safe operation of the attachment. The
  service manual contains safety and servicing procedures and a preventive maintenance schedule to
  ensure optimum machine performance.
• Section 1 in both the operator’s manual and the service manual contains safety information that must be
  followed. As well, throughout the rest of the manuals, WARNING and CAUTION notices are displayed
  where necessary, drawing attention to possible hazards when performing certain procedures.
• Only trained personnel should be allowed to operate or work on the machine.
• The information contained in this manual is current at time of printing. Improvements to the machine are
  on-going and may not be covered, therefore in these cases contact your Tigercat dealer for the
  appropriate information.
• The phrase “and up” appearing in this manual after the serial number implies that the related information
  is current for any machine serial number HIGHER than the serial number preceding the “and up”.
• Tigercat reserves the right to make changes to the machine after this manual release date that may not
  immediately appear in this manual.

TABLE OF CONTENTS:

Tigercat T726E TRENCHER OPERATOR’S MANUAL – PDF DOWNLOAD

T726E OPERATOR ……………………………………. 1
INTRODUCTION…………………………………… 3
S.A.E. STANDARDS……………………………….. 4
NON-APPROVED FIELD PRODUCT CHANGES……………….. 5
SECTION 1 – SAFETY…………………………………. 7
BOOM LIFT LOCK ………………………………… 18
ENGINE ACCESS PANELS …………………………… 19
FELLING TREES …………………………………. 13
FIRE PREVENTION ……………………………….. 25
DRY CHEMICAL CLEANUP PROCEDURES ……………… 29
FIRE PREVENTION GUIDELINES ………………….. 25
WHAT TO DO AFTER A MACHINE FIRE HAS OCCURRED ….. 28
WHAT TO DO TO PREPARE FOR A MACHINE FIRE ……… 26
WHAT TO DO WHEN A MACHINE FIRE OCCURS ………… 27
FLUID INJECTION INJURY …………………………. 20
GREASE INJECTION INJURY ………………………… 21
LIGHTNING SAFETY AWARENESS………………………. 7
LIGHTNING SAFETY …………………………… 22
WHAT IS A LIGHTNING STRIKE? …………………. 22
PARKING THE MACHINE ……………………………. 14
SAFETY INTERLOCK SWITCHES ON CAB DOORS …………… 15
SAFETY LABELS …………………………………. 30
SAFETY PRECAUTIONS, GENERAL …………………….. 8
SAFETY PRECAUTIONS, OPERATING …………………… 12
SAFETY PRECAUTIONS, SERVICING …………………… 16
SAFETY SYMBOLS ………………………………… 8
SIGNAL WORDS ………………………………….. 8
SECTION 2 – CONTROLS AND OPERATION…………………… 33
AIR CLEANER, ENGINE AIR ………………………… 64
AIR CLEANER UNLOADER VALVE ……………………… 64
AIR CONDITIONER/HEATER …………………………. 46
AIR VENTS …………………………………….. 46
ARTICULATION LOCK BAR ………………………….. 82
AUXILIARY POWER OUTLET …………………………. 60
BATTERY COMPARTMENT ……………………………. 86
BATTERY DISCONNECT SWITCH ………………………. 61
BOOM CYLINDER LOCK …………………………….. 83
BOOM LIFT LOCK ………………………………… 82
BRAKE FOOT PEDAL ………………………………. 41
BRAKES ……………………………………….. 41
BULB TEST – SWITCH …………………………….. 57
CAB CONTROLS QUICK REFERENCE ……………………. 37
CARE OF THE MACHINE ……………………………. 76
CARE OF POLYCARBONATE WINDOWS ……………….. 77
CAUTIONS ………………………………. 78
CLEANING INSTRUCTIONS …………………… 78
CONCEALING HAIRLINE SCRATCHES ……………. 78
FIRE PRECAUTIONS ……………………….. 79
GRAFFITI REMOVAL ……………………….. 79
INSPECTION AND MAINTENANCE ………………. 77
RESISTANCE TO CHEMICALS …………………. 77
RESISTANCE TO WATER …………………….. 77
CENTER JOINT LOCK BAR ………………………….. 82
CIGAR LIGHTER …………………………………. 60
CLEANING A/C CONDENSER, OIL COOLER AND RADIATOR …. 68
COMPRESSED AIR SYSTEM ………………………….. 65
CONTROL POD ON ARMREST, R.H……………………… 65
CONTROLS – CAB ………………………………… 39
CRUISE CONTROL ………………………………… 39
CUTTER SWITCH …………………………………. 54
DISPLAY MODULE ………………………………… 53
DOME LIGHT ……………………………………. 43
DRIVE CONTROL …………………………………. 40
DRIVE DIRECTION CONTROL ………………………… 39
DRIVE SPEED CONTROL ……………………………. 39
ENGINE ACCESS PANELS …………………………… 60
ENGINE AIR PRECLEANER ………………………….. 63
ENGINE, HOT WATER SHUT OFF VALVE ………………… 47
ENGINE, RESTARTING AFTER RUNNING OUT OF FUEL ……. 73
ENGINE, STARTING ………………………………. 73
ENGINE, STARTING, COLD WEATHER…………………… 33
CUMMINS …………………………………… 74
ENGINE, STOPPING ………………………………. 76
FAN SWITCH ……………………………………. 56
FILTER – CAB FRESH AIR …………………………. 47
FILTER, RECIRCULATING AIR – A/C UNIT …………….. 46
FIRE DETECTION SYSTEM ………………………….. 49
FIRE EXTINGUISHER ……………………………… 47
FOOT CONTROL, CENTER …………………………… 41
FOOT PEDAL, BRAKE ……………………………… 41
FOOT PEDAL, DRIVE SPEED ………………………… 40
FOOT REST …………………………………….. 41
FUEL TANK …………………………………….. 62
FUSE AND RELAY PANEL……………………………. 34
CAB ………………………………………. 37
MAIN ……………………………………… 85
FUSE PANEL ……………………………………. 60
GEAR SHIFT LEVER ………………………………. 40
HOT WATER SHUT OFF VALVE (ENGINE) ……………….. 47
HYDRAULIC HAND FILL PUMP ……………………….. 63
HYDRAULIC OIL RESERVOIR ………………………… 62
ICONS, PICTOGRAM DESCRIPTIONS …………………… 35
INSTRUMENT PANEL ………………………………. 38
JOYSTICK, BOOM ………………………………… 42
KEY SWITCH ……………………………………. 58
LEVER – GEAR SHIFT …………………………….. 40
LIGHT – DOME ………………………………….. 43
LIGHT SWITCHES ………………………………… 60
MACHINE PREPARATION ……………………………. 75
SYSTEM TEST AND WARM-UP …………………….. 75
MOVING INSTRUCTIONS ……………………………. 89
OPERATING MACHINE ……………………………… 70
PRE-START CHECKS …………………………… 70
PICTOGRAM DESCRIPTIONS …………………………. 35
PILOT RESET SWITCH …………………………….. 55
PILOT SYSTEM SHUT OFF ………………………….. 55
PRECLEANER, ENGINE AIR …………………………. 63
PRESSURIZED WATER SYSTEM ……………………….. 43
RELAYS AND WIRE CONNECTIONS …………………….. 87
SEAT …………………………………………. 44
SETTING DRIVE SPEED AND CRUISE CONTROL …………… 39
STARTING ENGINE ……………………………….. 73
STEERING WHEEL ………………………………… 42
STOPPING ENGINE ……………………………….. 76
TILT STEERING COLUMN …………………………… 42
TOWING INSTRUCTIONS ……………………………. 80
VEHICLE MOVING INSTRUCTIONS …………………….. 88
WAIT TO START …………………………………. 52
WARNING LIGHTS…………………………………. 34
FIRE DETECTION SYSTEM ………………………. 49
LOW FUEL LEVEL …………………………….. 52
LOW HYDRAULIC OIL LEVEL …………………….. 52
STOP LIGHT ………………………………… 52
WAIT TO START ……………………………… 52
WATER SPRAY SYSTEM COMPONENTS …………………… 66
WATER SYSTEM, PRESSURIZED ……………………… 43
WINDSHIELD WIPER SWITCH ………………………… 42
WINDSHIELD WIPER WASHER SWITCH ………………….. 42
WIRE CONNECTIONS – RELAYS ………………………. 87
SECTION 3 – LUBRICATION & MAINTENANCE………………… 91
AIR CLEANER MAINTENANCE …………………………110
AIR CONDITIONING SYSTEM, CHECKING ………………..114
BELT, ENGINE SERPENTINE, REPLACING ……………….119
BLINK CODES ……………………………………129
CENTER JOINT……………………………………115
LUBRICATION ………………………………..115
MAINTENANCE ………………………………..115
DRIVE SHAFT SPLINE LUBRICATION, MIDDLE AND REAR ……120
ELECTRONIC CONTROL MODULE ……………………….129
EMERGENCY EXITS, CHECK MONTHLY ………………….. 95
ENGINE SERPENTINE BELT, REPLACING ………………..119
FILTERS……………………………………….. 91
ENGINE AIR CLEANER ………………………….110
FUEL FILTER/WATER SEPARATOR ………………….106
FUEL TANK STRAINER ………………………….107
HYDRAULIC OIL RETURN FILTERS …………………108
HYDROSTATIC CHARGE PUMP PRESSURE FILTERS ……..109
SERVICING GUIDELINES FOR OIL FILTERS ………….109
FIRE PREVENTION ……………………………….. 96
HYDRAULIC OILS …………………………………101
NEW MACHINE MAINTENANCE…………………………. 91
FIRST 125 HOUR INSPECTION AND SERVICE REPORT ….. 92
INITIAL PRE-DELIVERY INSPECTION ……………… 92
TIGHTENING POINTS ………………………….. 92
OIL LOST FROM LEAKAGE ………………………….. 92
OIL SAMPLE COLLECTION PROCEDURES ………………… 94
OIL SAMPLING PROGRAM …………………………… 93
PRESSURIZED WATER SYSTEM MAINTENANCE ……………..112
PRIMING THE FUEL SYSTEM …………………………106
REPLACING THE ENGINE SERPENTINE BELT ……………..119
SCHEDULED MAINTENANCE…………………………… 91
GENERAL …………………………………… 95
8 HOURS …………………………………… 97
40 HOURS ………………………………….. 97
125 HOURS …………………………………. 98
250 HOURS …………………………………. 98
500 HOURS …………………………………. 99
1000 HOURS ………………………………… 99
2000 HOURS …………………………………100
SEASONAL …………………………………..100
SERVICE AND LUBRICATION POINTS CHART ……………..103
STARTUP PROCEDURE AFTER MAINTENANCE ………………116
TORQUE CHART …………………………………..122
TORQUE, FLUID CONNECTIONS ……………………….124
TORQUE SPECIFICATIONS – GENERAL ………………….122
TRANSMISSION CHECK OIL LEVEL …………………….115
WHEELS, INSTALLING …………………………….. 92

IMAGES PREVIEW OF THE MANUAL:

TIGERCAT T726E TRENCHER OPERATOR’S MANUAL – PDF DOWNLOAD:

PLEASE NOTE:

• This is the SAME manual used by the dealers to troubleshoot any faults in your vehicle. This can be yours in 2 minutes after the payment is made.
• Contact us at [email protected] should you have any queries before your purchase or that you need any other service / repair / parts operators manual.

S.V